Thursday, August 20, 2015


   This great idea was found at www.unexpectedelegance.com .  A very cool idea that could be used on many different things and ways.  Good luck and may creativity strike you!

Wax Paper Transfer Tutorial

I have been playing around with a lot of mediums lately, one being iron on transfers. I had bought some the other day, but they are pretty expensive if you only make one item per sheet. So I thought I would try an alternative. The only thing I had around was wax paper, so I gave it a try and it worked GREAT!
I am betting that I’m not the first person to try this, but if you have never tried it, here are a few things I took away from trial and error.
I used an old wooden pizza peel, wax paper, an inkjet printer and a credit card.
I found that if you wet the wood a little, it would make the transfer darker. Just make sure it’s not too wet, then the ink will run (a happy balance).
Cut the wax paper to the size of printer paper.
I used a graphic from The Graphics Fairy…she has the BEST blog!! Check it out for some really great stuff!
You will need to reverse the image. Most computers have the program “Paint.” If you aren’t sure just do a search for it in your start bar. Open the picture you want to flip, then go to “Image” in the top bar. There is a drop-down option for “Flip/Rotate.” That should reverse the image for you.
Put the wax paper in the printer and make sure it’s under the rollers, but not too far in. If you put it on top of printer paper, you can use the paper as a guide on how far the wax paper needs to be in the printer.
Stand close to the printer and help guide the wax paper out. OH, and make sure there are no wrinkles!! It can cause the wax paper to get jammed.
You will have to work quickly, but once you set the wax paper down you CAN NOT move it.
Try to line up the paper then gently lay it on the surface you want to transfer it to. Holding the wax paper firmly down, use a credit card to gently scrap the surface.
Then carefully remove the paper. It will still have ink, so be careful not to drag it.
Here are the two sides of the board, the first one is without getting the board wet and the second one is damp. You can see that the second is much darker but the paper moves easily so it smeared a little. It all depends on the look you want.
This project takes about 10 minutes and is super cheap. I think I will be using this A LOT. It works on fabric too, but the thread has to be really tight for the best results.
Hopefully, I have taught you something you didn’t know! ;)

No comments:

Post a Comment